The pressure energy of compressed gas is converted into mechanical in pneumatic transmission
Pneumatic actuators. The cylinder has two types of reciprocating linear motion and reciprocating swing (see figure). The cylinders that make reciprocating linear motion can be divided into four types: single-acting cylinder, double-acting cylinder, diaphragm cylinder and impact cylinder.
1 single-acting cylinder: only one end has a piston rod, the air supply from the side of the piston can generate air pressure, and the air pressure pushes the piston to generate a thrust, and returns by spring or self-weight.
2 double-acting cylinder: alternately supply air from both sides of the piston, outputting force in one or two directions.
3 Diaphragm cylinder: replace the piston with a diaphragm, output the force only in one direction, and reset with a spring. Its sealing performance is good, but the stroke is short.
4 Impact Cylinder: This is a new type of component. It converts the pressure energy of the compressed gas into the kinetic energy of the high-speed (10~20 m/s) movement of the piston, thereby doing work.
5 Rodless cylinder: A general term for cylinders without a piston rod. There are two types of magnetic cylinders and cable cylinders.
The cylinder that makes the reciprocating swing is called the swinging cylinder, and the inner chamber is divided into two by the vane, and the air is alternately supplied to the two chambers, and the output shaft is oscillated, and the swing angle is less than 280°. In addition, there are rotary cylinders, gas-liquid damping cylinders and stepping cylinders.